Description
FDR D-EVO III G43 17 x 17” Detector Panel Only
Features:
Fujifilm’s lightest DR detector with flexible film-based TFT circuitry
By replacing the glass-based TFT layer with a high-tech thin film layer, FDR D-EVO III is 40% lighter than the original 1st generation FDR D-EVO model and 20% lighter than FDR D-EVO II.
Higher DQE 33% (1Lp/mm-RQA5 1mR)
Innovative film-based capture layer helps reduce signal blur, providing excellent DQE and dose performance.
Enhanced durability to endure tough medical environments
By eliminating the most fragile (glass) component, the new flexible film-based TFT detector improves durability and decreases risks of shock damage compared to previous FDR D-EVO models.
Patented ISS capture technology promotes high sensitivity
Equipped with Fujifilm’s patented Irradiated Side Sampling (ISS) technology which bonds its capture electronics (TFTs) to the x-ray irradiation side, in contrast to traditional detectors. This design suppresses scattering and attenuation of x-ray signals, to produce sharper images at lower doses compared to traditional designs.
Unique formulation of large and small phosphor particles at a optimal ratios, enhances x-ray absorption
Increased x-ray absorption is achieved through our uniquely formulated scintillator layer, which employs photographic film technology to optimize the blending ratio of phosphor particles to minimize blur and enhance sharpness.
Fujifilm’s noise reduction circuitry improves detector sensitivity in high absorption and low dose images
Uniquely engineered noise reduction circuitry reduces noise in the image to improve signal strength. This results in 33% DQE even at 0.1mR. The granularity and visibility of dense, low penetration or ultra low dose regions are improved.
Improved handling
Simple battery replacement workflow
The battery can easily be replaced with one hand and the detector can be back up and ready in ~90 seconds. This eliminates concerns about battery life or on-demand battery swaps even in the midst of critical care.
Suitable for outdoor use with an expanded spectrum
Supports 2.4GHz and 5GHz (W52/53/56/58)* spectrum. Suitable for outdoor use during disaster response.
Memory Mode
Dedicated memory mode enables added emergency uses. Built-in memory stores up to 100 images. Images are retained even if detector power is interrupted. Digital readout on detector face tracks images stored and increments as they are acquired.
Flexibility – On-Demand Use
FDR D-EVO III’s unique combination of form and function brings significant value to traditional room retrofit and mobile uses. The additional capabilities of Memory Mode and Smart Switch bring added value for emergency, on-demand backup and failsafe uses with any portable, room or even for remote off-site and disaster response uses.
Advanced image processing
Virtual Grid: High quality images without a physical grid
Advanced processing simulates scatter clean up without a physical grid, correcting for the effects of scatter radiation while retaining contrast and sharpness. Eliminating the grid improves patient comfort, simplifies positioning and allows as much as 50% lower dose compared to grid exams. Grid cutoff and retakes associated with misalignment of X-ray tube and grid are also prevented.
Dynamic Visualization II: Intelligent feature recognition technology optimizes image quality
Advanced algorithms optimize contrast and density based on anatomic definition, hardware and thickness characteristics, resulting in outstanding detail and greater window and leveling capability in PACS.
Specs:
- Type: Detector with patented ISS (Irradiation Side Sampling) and flexible film-based TFT detector technology
- Scintillator: GOS (Gadolinium oxysulfide)
- Detector external size: 18 x 18 x 0.6″ approx. (460 x 460 x 15mm)
- Weight: 4.6 lbs. (2.1 kg) excludes battery
- Pixel pitch: 150μm, 16 bits per pixel
- Pixels: 2836 x 2336 pixels
- Image preview: Less than 2 sec
- Cycle time: Less than 10 sec (wired), Less than 11 sec (SmartSwitch)
- Battery recharging time: Approx. 3 hours (with battery charger), Approx. 4 hours (with Docking Stand)
ADDITIONAL Configurations:
ADD FDX
ADD Docking Stand
ADD Power Box
FDR D-EVO III Accessories
16648725 FDR D-EVO III Battery (standard)
16648737 FDR D-EVO III Battery Charger Upgrade Kit
800049194 FDR D-EVO III Battery Charger Kit
800051782 FDR D-EVO III 25×30 weight bearing cap
